ONE NETWORK.
EVERY CONNECTION.
Real-time USRP routing telemetry, monitored Linux services, and operator controls for the SWLA-LINK digital link system.
Network at a glance
Bridge engine
Service health
Configured endpoints
Last heard
USRP ENDPOINTS
Create port mappings for your existing Analog_Bridge, AllStar or other USRP-capable processes. New mappings are staged until service restart.
Endpoint inventory
Add a USRP endpoint
Saving a port mapping does not bind a UDP listener immediately. Check existing service configurations, firewall exposure, NAT, and peer source ports before restarting LinkCore. It will not modify DVSwitch or AllStar for you.
YSF ↔ DMR BRIDGE
Connect the System Fusion reflector to the DMR Homebrew network. Configuration takes effect immediately—no LinkCore restart required.
Configure both sides of the bridge
Connection diagnostics
Recent gateway logs
No logs yet.
A running gateway process is not proof that the reflector or DMR master accepted its connection. LinkCore reports the process state and its logs honestly. Enter verified endpoints; this bridge can carry real traffic once connected. Avoid loops with existing YSF-to-DMR links and keep the old bridge in place until on-air tests pass.
NATIVE M17 RECEIVER
Connect directly to an M17 reflector without DVSwitch. Receive actual callsigns, streams and Codec2 audio. No RF transmit, bridge forwarding or external key-up occurs in this release.
Direct reflector receiver
Connect your M17 reflector
Only M17 control handshakes and keepalives are sent to the configured reflector. Voice frames are never transmitted. Receive audio requires system libcodec2 at 3200 bit/s. Public connection indicators reflect actual reflector acknowledgments, not a local process running. Confirm your reflector host and module with its administrator before enabling.
ROUTE MANAGER
Build directed audio paths, enable policies, and prevent multi-node routing cycles.
Define a route
Directed connections
USRP source addresses are checked, transmitters are serialized, and a watchdog sends unkey when a source becomes stuck. External paths can still form loops outside LinkCore. Keep independent RF timeout and emergency-disconnect safeguards.
NETWORK ACTIVITY
Read-only history of operator actions, service changes and router events, plus packet counters from this process.
Audit trail
CONNECTION DIRECTORY
Published identifiers are reference information, not confirmation of live remote network status.
SWLA-LINK connections
PUBLIC BRIDGE DASHBOARD
Configure the public status page that appears at link.swlalink.com ↗. It shows actual local service/USRP telemetry and authenticated adapter event reports; it never exposes private routing or operator sessions.
Public status page settings
Activity rows are added only by installed local adapter integrations. LinkCore cannot infer a callsign, BER, packet loss or RX monitor audio stream from an ordinary USRP packet. These fields will remain empty until authentic adapters are connected. Public GET endpoints do not expose systemd unit names, private addresses or admin configuration.
SYSTEM SETTINGS
Set up live, read-only systemd monitoring and inspect LinkCore configuration without changing radio processes.
Monitored services
Choose services actually installed on this server. Unit names are not treated as active until systemd confirms them.
LinkCore configuration
This dashboard monitors local systemd services but does not start, stop or rewrite existing DVSwitch services. USRP endpoints are staged. Digital codecs and transcoding remain in their existing services. Public access is through your HTTPS Nginx reverse proxy at link.swlalink.com.